AC3D Forums - View Single Post - Hollow pipe-how to

mconn1 · 19th December 2004, 04:15 PM

Sorry to jump in here, but I think Dughor was closer than he realized.

I found that the making a disk, combining surfaces, then making a hole, at 85%, then extruding worked very well.

19th December 2004, 04:15 PM	#11
mconn1 Member Expert member Join Date: Dec 2003 Posts: 55	Sorry to jump in here, but I think Dughor was closer than he realized. I found that the making a disk, combining surfaces, then making a hole, at 85%, then extruding worked very well.