AC3D Forums - View Single Post

Terry Capps · 17th June 2006, 08:42 PM

As a matter of fact, I have placed the part models in an Object-->Library.

The circuit board, that I illustrated, processes position-angle signals and sends out an alarm signal to a piezo device when an invalid set of position angles is detected. It is part of a "Sleep Position Monitor" that I designed for myself. Due to a back injury, I have to limit the positions that I can sleep in to two positions. If I get into a bad position, the monitor will sound an alarm and wake me.

The bottom side of the board wasn't shown in the image that I sent. The texture mapping for it shows the other traces that connect to the components. The texture mapping that you can see in the image that I sent is just the top-side artwork.

17th June 2006, 08:42 PM	#7
Terry Capps Senior Member Professional user Join Date: Dec 2004 Location: Corsicana, Texas Posts: 133	Re: Printed Circuit Board Model As a matter of fact, I have placed the part models in an Object-->Library. The circuit board, that I illustrated, processes position-angle signals and sends out an alarm signal to a piezo device when an invalid set of position angles is detected. It is part of a "Sleep Position Monitor" that I designed for myself. Due to a back injury, I have to limit the positions that I can sleep in to two positions. If I get into a bad position, the monitor will sound an alarm and wake me. The bottom side of the board wasn't shown in the image that I sent. The texture mapping for it shows the other traces that connect to the components. The texture mapping that you can see in the image that I sent is just the top-side artwork.