AC3D Forums - View Single Post - how would I make the spout part that you find on a workmen's bucket?

HowDo · 5th August 2009, 02:51 PM

I think I might use the last idea, sound about what I think I want, I think if I round the edges and then cut the shape out it might work.

About the only way I did not think you try.

Thanks again.

5th August 2009, 02:51 PM	#3
HowDo Member Advanced member Join Date: Nov 2007 Posts: 33	Re: how would I make the spout part that you find on a workmen's bucket? I think I might use the last idea, sound about what I think I want, I think if I round the edges and then cut the shape out it might work. About the only way I did not think you try. Thanks again.