Quote:
Originally Posted by CGMike
Hmm.. I'll give that a try, though it happens to me whether I'm working on my home keyboard or at work on my work keyboard.. the likelihood of the same exact key sticking in two different places seems a bit remote to me.
|
It does seem very unlikely. AC3D must be getting the direction to perform the extrusion twice from somewhere, however.
I don't believe it's possible to have the edge extrusion happen twice without two extrusion commands being sent to AC3D (via keyboard/menu/button), but only Andy/Inivis could verify this. As before, however, if you can repeat it via button/menu rather than keyboard, that would certainly give them something to look at.
I find I *can* reproduce this by holding down the "E" key just a tad longer than normal (my keyboard repeat rate is set to the shortest delay possible). If I turn down the key repeat rate to Long, it ceases to happen, of course.
Good luck