Thread: Rounded corners
View Single Post
Old 10th March 2012, 02:09 PM   #6
Andy
Administrator
Professional user
 
Andy's Avatar
 
Join Date: Jun 2003
Posts: 4,563
Default Re: Rounded corners

You could try this:

Make a cylinder (you need to use a cylinder for this since a disk will extrude differently) that has the radius of the corners you want. This one had 60 segments to make a nice curve.

Select half of it (the right-hand side here) and extrude, select the other half of it (bottom here) and extrude again.


Hold down the control-key when extrudng to keep it square.

If you need just the rectangle part, you can select the other surfaces and just keep a single 'side'. If you then want a single polygon, press 'c' to Surface->Combine all surfaces into one.
Attached Images
 
Andy is offline   Reply With Quote