AC3D Forums - View Single Post

LightWizard · 7th December 2008, 05:02 PM

I have a hot tub that came with a grotto I got in SL. It's a cylinder (in SL sizes) about .25 meters thick, forming the round walls of the pool, and it has a bottom disk to act as its bottom (about the same thickness. I can fit within the cylinder/hot tub and it has normal touch/physical boundaries. It's not made physical, though I'm sure it would act the same wrt boundaries (it's obviously not phantom either).

My next naive trick will be to try to create such a cylinder. I'll start with the cylinder and see if I can mold it around to a similar shape. I haven't yet had a chance to try, so this may be a vain attempt, but I'll see if I can do it with that technique.

Any suggestions for making such a cylinder would be much appreciated...I'll report back after (likely tomorrow eve).

Again, thanks...LW

7th December 2008, 05:02 PM	#15
LightWizard Junior Member Member Join Date: Dec 2008 Posts: 11	Re: Need help creating Second Life Sculpties I have a hot tub that came with a grotto I got in SL. It's a cylinder (in SL sizes) about .25 meters thick, forming the round walls of the pool, and it has a bottom disk to act as its bottom (about the same thickness. I can fit within the cylinder/hot tub and it has normal touch/physical boundaries. It's not made physical, though I'm sure it would act the same wrt boundaries (it's obviously not phantom either). My next naive trick will be to try to create such a cylinder. I'll start with the cylinder and see if I can mold it around to a similar shape. I haven't yet had a chance to try, so this may be a vain attempt, but I'll see if I can do it with that technique. Any suggestions for making such a cylinder would be much appreciated...I'll report back after (likely tomorrow eve). Again, thanks...LW