Quote:
Originally Posted by Lucky1
If I make an "L" with a Polyline of 3 points, it appears that I cannot
"unweld" the corner vertex since it was always only one vertex.
I can't make the other tools do it either.
|
OK, so by the silence I will take it that once a line is drawn straight that curving only one segment of it isn't possible.
I should draw each segment separately to begin if I have any intention of curving it in the future.
Another question then if I may, once the whole piece/design is complete, and it's been given a surface,
how do I make the whole unit say 1/8" thick? Right now it's "paper thin".
Thanks!
Wes