I have successfully created a group of objects for the interior of my Remos GX project, and they show up just fine when in 3D cockpit mode (CTRL-O). However, none of them show up in exterior views. I have all the Viewpoint options selected properly (I think):
In case the image doesn't show up above, I have the entire top row and bottom row of the Aircraft and Panel Visibility checked ON.
I tested out another airplane (the Tampico T9) that uses misc objects in Planemaker for the interior, and its objects show up just fine in external views. I further tested by swapping a couple of the Tampico's misc objects into my Remos objects folder and attaching them in Planemaker - they show up! I then did the reverse, and put a couple of my objects into the Tampico objects folder and attached them in Planemaker. Mine do NOT show up!
Leads me to believe that I am exporting my objects from AC3D improperly...
Any suggestions? Is there something I need to change about how I'm exporting the objects? Maybe something I'm missing inside PlaneMaker? Other?
Thanks!