AC3D Forums - View Single Post

Michael Wilson · 18th October 2017, 04:09 PM

"Are using AC3D's texture LSCM Unwrap? It's very powerful but you need to select non-joined areas for it to work well. If you select the whole cylinder, the algorithm doesn't know where you want the edges of the mapping. So, on a cylinder/fuselage, select then map one half at a time."

thats what i was doing, right and left half fuselage separately. it has a bug where it splits the half into two pieces and then you have to put it together, thats not too hard for me on a simple test cylinder but with a fuselage that has a nose it doesnt seem to work. this is what i get using a test cylinder and then this fuselage:

18th October 2017, 04:09 PM	#4
Michael Wilson Member Expert member Join Date: Dec 2005 Posts: 78	Re: how about this program for unwrapping? "Are using AC3D's texture LSCM Unwrap? It's very powerful but you need to select non-joined areas for it to work well. If you select the whole cylinder, the algorithm doesn't know where you want the edges of the mapping. So, on a cylinder/fuselage, select then map one half at a time." thats what i was doing, right and left half fuselage separately. it has a bug where it splits the half into two pieces and then you have to put it together, thats not too hard for me on a simple test cylinder but with a fuselage that has a nose it doesnt seem to work. this is what i get using a test cylinder and then this fuselage: Attached Thumbnails Last edited by Michael Wilson; 18th October 2017 at 04:14 PM.