AC3D Forums - View Single Post

zilverenmist · 11th October 2010, 05:36 PM

Hi, this is how I make propellor blades:
start with a cylinder and extrude the walls a bit, shape these vertexes in the blade shape extrude and rotate in the desired shape untill you have 1 propellor

than use the replicator:

This is the result:

11th October 2010, 05:36 PM	#8
zilverenmist Member Advanced member Join Date: Dec 2008 Location: Netherlands Posts: 32	Re: Aircraft prop blades Hi, this is how I make propellor blades: start with a cylinder and extrude the walls a bit, shape these vertexes in the blade shape extrude and rotate in the desired shape untill you have 1 propellor than use the replicator: This is the result: __________________ If it does not work, I'll try again