AC3D Forums - View Single Post

TomToad · 21st September 2004, 04:33 PM

I find the easiest way to select single surfaces is to CTRL-Left click on the 3D window. To select more than one surface, use SHIFT-CTRL-left click on each additional surface.

Vertices are a little more difficult because it's sometimes hard to determine where on the 3D model the vertice exists. So I click on the vertice in one of the 2D models so it will be highlighted on the 3D model. If only one is selected, then great. If not, then I can CTRL-left click on the vertice I wish to keep.

21st September 2004, 04:33 PM	#2
TomToad Junior Member Junior member Join Date: Jul 2004 Posts: 8	I find the easiest way to select single surfaces is to CTRL-Left click on the 3D window. To select more than one surface, use SHIFT-CTRL-left click on each additional surface. Vertices are a little more difficult because it's sometimes hard to determine where on the 3D model the vertice exists. So I click on the vertice in one of the 2D models so it will be highlighted on the 3D model. If only one is selected, then great. If not, then I can CTRL-left click on the vertice I wish to keep.