AC3D Forums - View Single Post

mhoyle · 7th April 2008, 06:40 PM

hoping someone can help me on what i'm sure is very easy but can't quite seem to get it:

i want to create a street corner. for an urban scene i'm doing.

specifically i was trying to get a rectangle as my base and then curve one of the edges for the corner.

then i wanted to manipulate (push/pull) the vertices to give that organice imperfection to the corner where it dips down for bikes and pedstrians near the curb.

and i'm sure there's probably an easier way to do it but:
what i can't seem to do is after drawing a rectangle and then a cylinder which i butt up to one of the rectangle corners. i want to then merge the two together and cut that extra bit of corner where the cylinder has joined the rectangle, off. thus making a curved edge on a rectangle.

any help would be appreciated.

7th April 2008, 06:40 PM	#1
mhoyle Junior Member Member Join Date: Apr 2008 Posts: 12	very noob question but here goes: hoping someone can help me on what i'm sure is very easy but can't quite seem to get it: i want to create a street corner. for an urban scene i'm doing. specifically i was trying to get a rectangle as my base and then curve one of the edges for the corner. then i wanted to manipulate (push/pull) the vertices to give that organice imperfection to the corner where it dips down for bikes and pedstrians near the curb. and i'm sure there's probably an easier way to do it but: what i can't seem to do is after drawing a rectangle and then a cylinder which i butt up to one of the rectangle corners. i want to then merge the two together and cut that extra bit of corner where the cylinder has joined the rectangle, off. thus making a curved edge on a rectangle. any help would be appreciated.