AC3D Forums - View Single Post

wynthorpe · 14th February 2009, 05:42 AM

Thanks Gahoo

The base is actually one piece constructed by extruding and changing the width. The point where it goes wide again is a band around the tower that i created by creating an elipse and extruding to 0.3 and palcing around the base.

14th February 2009, 05:42 AM	#3
wynthorpe Junior Member Junior member Join Date: Feb 2009 Posts: 5	Re: ENVA ATC Tower Thanks Gahoo The base is actually one piece constructed by extruding and changing the width. The point where it goes wide again is a band around the tower that i created by creating an elipse and extruding to 0.3 and palcing around the base.