AC3D Forums - View Single Post

Spkier · 16th December 2019, 06:21 AM

So would you say it's worth the 140$?
looking at the updates there has not been one since 2018.
How about Cockpit modelling is that working good or is it hard?
does it have any NURMS NURBS or turbosmooth modifier? any modifiers at all?

Does it support inset, bevel, knife cutting, etc?
Does this modelling software have a discord like blender and 3dsmax has?
kinda helps getting faster reponse thru a site where everybody uses

16th December 2019, 06:21 AM	#3
Spkier Junior Member Junior member Join Date: Dec 2019 Posts: 8	Re: Worth getting AC3D? So would you say it's worth the 140$? looking at the updates there has not been one since 2018. How about Cockpit modelling is that working good or is it hard? does it have any NURMS NURBS or turbosmooth modifier? any modifiers at all? Does it support inset, bevel, knife cutting, etc? Does this modelling software have a discord like blender and 3dsmax has? kinda helps getting faster reponse thru a site where everybody uses Last edited by Spkier; 16th December 2019 at 06:28 AM.