AC3D Forums - View Single Post

tbd · 15th August 2006, 12:02 PM

6. Now drag the vertices a little bit down and backward. This is to get some edges in the panel.

7. Now extrude edges again and pull it bacward and maybe widen it a bit depending on your craft. Just as in the picture. Keep on extruding edges and pulling into shape until you have the front finished.
A little word of warning. Do not deselect the vertices after extruding without having pulled them first. You will have a hard time getting the right vertices selected again.

8. Select the vertices on the side and do the same thing here.You dont need the first down bit here as seen in picture 9.

9. The side panels are also used as floor, so when you are aligned with the bottom of the chair, just extrude and push the vertices
together. The complexety of the panels are up to you.

10. Select the back vertices and do the same thing here. Extrude and pull.

15th August 2006, 12:02 PM	#2
tbd Senior Member Professional user Join Date: May 2005 Location: Norway Posts: 883	Re: Making a cocpit 6. Now drag the vertices a little bit down and backward. This is to get some edges in the panel. 7. Now extrude edges again and pull it bacward and maybe widen it a bit depending on your craft. Just as in the picture. Keep on extruding edges and pulling into shape until you have the front finished. A little word of warning. Do not deselect the vertices after extruding without having pulled them first. You will have a hard time getting the right vertices selected again. 8. Select the vertices on the side and do the same thing here.You dont need the first down bit here as seen in picture 9. 9. The side panels are also used as floor, so when you are aligned with the bottom of the chair, just extrude and push the vertices together. The complexety of the panels are up to you. 10. Select the back vertices and do the same thing here. Extrude and pull. Attached Images __________________ ..............<<<<My Blog>>>>...........