Re: extruding a polygon 8.0.80 can't get endcap, what am I doing wrong?
Hey!!!! look at that!!! its a drag partition and there are other options that were hidden!!! Thank you!!!!
FWIW, attention AC3D developers: there is supposed to be a drag bar indicator to the right of a boxed section if you can't see the entire box to tell the users there is more below. If you notice in the screen shot, the "Utils" boxed section is properly formed and has a drag bar to the right to tell users there is more that is not visible, When the Extrude box is too short and hides the last two checkboxes (as in my screencap shown in the original post,) you'll notice the Extrude option box does not have a drag bar on the right and I had no idea there were more options than cap end.
Last edited by jleslie; 5th March 2017 at 12:49 PM.
|