AC3D Forums - View Single Post

gogosAC · 26th June 2022, 04:03 AM

Hello Andy,

did some tests:

1) normally placed surface (2S) -> then extrude edge

2) surface (selected as surface or object) switched to 1S (my normal work-mode)

-> then extrude edge -> added surface = transparent -> CORRECTION: in this case the normal was flipped

BUT (picture above, yellow circles) flip normals doesn't help -> "real" transparent (should be white(1) ??), but texturing possible

26th June 2022, 04:03 AM	#4
gogosAC Member Advanced member Join Date: Jun 2018 Posts: 44	Re: extruding without texture Hello Andy, did some tests: 1) normally placed surface (2S) -> then extrude edge 2) surface (selected as surface or object) switched to 1S (my normal work-mode) -> then extrude edge -> added surface = transparent -> CORRECTION: in this case the normal was flipped BUT (picture above, yellow circles) flip normals doesn't help -> "real" transparent (should be white(1) ??), but texturing possible Last edited by gogosAC; 26th June 2022 at 04:19 AM.