AC3D Forums - View Single Post - how would I make the spout part that you find on a workmen's bucket?

HowDo · 1st August 2009, 10:26 AM

Hi

Been tring lots of way in gettting the shape of a spout that you find in a workmen's bucket, what every I try, it either ends up with to many polys or it does not join or cut out right.

the bucket shape is easy, but putting the spout on it ??

how shoul I go about it.

1st August 2009, 10:26 AM	#1
HowDo Member Advanced member Join Date: Nov 2007 Posts: 33	how would I make the spout part that you find on a workmen's bucket? Hi Been tring lots of way in gettting the shape of a spout that you find in a workmen's bucket, what every I try, it either ends up with to many polys or it does not join or cut out right. the bucket shape is easy, but putting the spout on it ?? how shoul I go about it.