AC3D Forums - View Single Post - Is it possible to leave the surface smooth at once?

fabrizio fracaroli · 18th May 2010, 06:17 PM

First, Thanks a lot for your help, Stiglr, and Toronto...
I do not have this crease angle in tools, i found it in the settings,ok. it is seting in 45, "degrees"?
must i set for what degree?
I have read your reply, but i do not make any modification. I will wait for the next reply and then i will try to do anything to enhance this surface, if possible.
thanks again... oh i want yes, i want your help thanks.
who does not?

18th May 2010, 06:17 PM	#5
fabrizio fracaroli Junior Member Member Join Date: Apr 2010 Location: Brazil Posts: 21	Re: Is it possible to leave the surface smooth at once? First, Thanks a lot for your help, Stiglr, and Toronto... I do not have this crease angle in tools, i found it in the settings,ok. it is seting in 45, "degrees"? must i set for what degree? I have read your reply, but i do not make any modification. I will wait for the next reply and then i will try to do anything to enhance this surface, if possible. thanks again... oh i want yes, i want your help thanks. who does not?
$fabrizio fracaroli is offline$