AC3D Forums - View Single Post

INNIS · 27th October 2003, 07:55 AM

Hi Guys
This is my first post on the forum unfortunately it is a problem.
I have used AC3D for about 6 months to make and change
aircraft models for the open source flight sim flightgear.
In 3.6 I had no problems.
But I find now with 4.0 every time I go to use a model saved
from 4.0 I get this error on sim startup.
FATAL: ac to gl:unrecognised token 'crease 45.0000'
This occurs even if I do nothing to the model other than
resave it.
If I then replace the 4.0 created model with its 3.6 equivalent
model all works perfectly again.

Any help would be greatly appreciated.I dont want to go back to
3.6 if I can help it

Thanks in advance

cheers
Innis

27th October 2003, 07:55 AM	#1
INNIS Member Advanced member Join Date: Oct 2003 Location: Australia Posts: 34	Problems with AC3D 4.0 Hi Guys This is my first post on the forum unfortunately it is a problem. I have used AC3D for about 6 months to make and change aircraft models for the open source flight sim flightgear. In 3.6 I had no problems. But I find now with 4.0 every time I go to use a model saved from 4.0 I get this error on sim startup. FATAL: ac to gl:unrecognised token 'crease 45.0000' This occurs even if I do nothing to the model other than resave it. If I then replace the 4.0 created model with its 3.6 equivalent model all works perfectly again. Any help would be greatly appreciated.I dont want to go back to 3.6 if I can help it Thanks in advance cheers Innis