25th November 2005, 02:26 AM | #1 |
Junior Member
Member
Join Date: Nov 2005
Posts: 17
|
Subdide Problems
I was wondering if there is a better way to round off flat surfaces then the 'subdivide' tool. the problem is that i made a trace of a mech from mobile suit gundam (the zaku) then 'extruded' it to find that its too blocky, so i used the subdivide tool and it works... sort of. the new problem is that it creates little rinckles on the surface. is there a better way? thanks.
--Scott
__________________
The future is upon us... http://www.freewebs.com/mech-sys/index.htm http://mechsys.proboards77.com/ |
|
|