![]() |
#1 |
Senior Member
Professional user
Join Date: Nov 2004
Posts: 191
|
![]()
http://www.tomah.com/delliott/panel1.gif
Question I would like to bevel the two lower to edges of this panel. meaning bend them inward along there lower edges slightly, or make a crease along that edge, elimanating the sharp edge, is this possible :?: |
![]() |
![]() |
![]() |
#2 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
![]()
Extrude the shape forward (unset all the extrude checkbox options) and shrink the original section.
Andy |
![]() |
![]() |
![]() |
#3 |
Senior Member
Professional user
Join Date: Nov 2004
Posts: 191
|
![]()
The first part I understand, the second I don't ... shrink what and how with the xyz or the -10 percent and what does this shrinkage do. Thanks :?:
|
![]() |
![]() |
![]() |
#4 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
![]()
Yes the -10% would be fine but you will have finer control over the scaling if you hold down the control key and resize a corner.
Andy |
![]() |
![]() |
![]() |
|
|