|
11th November 2018, 10:55 AM | #1 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
Re: Subtract a tube from a wall
There are many requirements for booleans to work correctly. Both objects must be fully enclosed 3D shapes with no holes, and all normals facing outwards. After hearing that you had to remove so many duplicate vertices, I suspect the main shape is not perfect for this.
Try selecting Tools->select-leaky surfaces and seeing if anything is selected. It may be too much to fix so I'd suggest making the shape you want and moving that into position to replace the 'wall' where you want the hole area. |
11th November 2018, 01:23 PM | #2 | |
Junior Member
Member
Join Date: Nov 2018
Location: Haute-Savoie, France
Posts: 14
|
Re: Subtract a tube from a wall
Quote:
Will all my X-plane sketchup .obj export when ac3d re-imported will be the same ? Best, Chris |
|
11th November 2018, 05:04 PM | #3 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
Re: Subtract a tube from a wall
I can't say for sure, but it's possible that the stuff coming out of Sketchup is not perfectly optimized for use elsewhere.
Leaky means that you have holes or open edges e.g. polygons that are close to each other but their vertices aren't shared. Modeling with a leaky object is fine, unless you want to use Booleans (Booleans need 'solid' objects). If the object you have looks like it should be non-leaky i.e. no obvious holes, you might try this: Object->Optmize-vertices Object->Optimize-surfaces Then try Tools->Select-leaky-surfaces. If it says you have holes, you could try Object->fill-holes. You can quickly check for normals being oriented by selecting everything and setting it to single sided ("1S" button). If you look around and see any holes, some surfaces are facing the wrong way. Surface->Unify-normals can fix this. It all depends what the initial model is like. Last edited by Andy; 11th November 2018 at 05:11 PM. |
12th November 2018, 04:13 PM | #4 | |
Junior Member
Member
Join Date: Nov 2018
Location: Haute-Savoie, France
Posts: 14
|
Re: Subtract a tube from a wall
Quote:
Best, Chris Last edited by cpot; 12th November 2018 at 04:23 PM. |
|
13th November 2018, 04:29 PM | #5 |
Junior Member
Member
Join Date: Nov 2018
Location: Haute-Savoie, France
Posts: 14
|
Re: Subtract a tube from a wall
Hi,
I tried all your suggestions without success. Therefore i tried to simplify the problem by creating a tube and 'knife' it in a single surface of the wall. i obtained the attached result (not a hole in the wall) Did i do something wrong ? Best Chris |
14th November 2018, 04:22 AM | #6 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
Re: Subtract a tube from a wall
try doing the knife with a cylinder (i.e. enclosed 3d shape), not a tube.
Last edited by Andy; 14th November 2018 at 04:25 AM. |
17th November 2018, 03:36 PM | #7 |
Junior Member
Member
Join Date: Nov 2018
Location: Haute-Savoie, France
Posts: 14
|
Re: Subtract a tube from a wall
|
|
|