Texturing problems

Greasetattoo · 25th December 2007, 09:51 PM

I believe I figured it all out...
Just playing around with the program..

What I did was just picked the front faces of the can and applied the label. Then, I picked all the back faces and applied the label again, I had to flip it, though, to correct the reverse.

This Bud's for you!

Cool...
GREAT program!
Grease

P.s. What I do is export my model into Papakura and make a true 3D paper model...

25th December 2007, 09:51 PM	#3
Greasetattoo Member Expert member Join Date: Mar 2007 Location: Minnesota Posts: 97	Re: Texturing problems I believe I figured it all out... Just playing around with the program.. What I did was just picked the front faces of the can and applied the label. Then, I picked all the back faces and applied the label again, I had to flip it, though, to correct the reverse. This Bud's for you! Cool... GREAT program! Grease P.s. What I do is export my model into Papakura and make a true 3D paper model... Attached Thumbnails