16th January 2005, 09:29 AM | #1 |
Senior Member
Professional user
Join Date: Nov 2004
Posts: 191
|
Shaping edge
http://www.tomah.com/delliott/panel1.gif
Question I would like to bevel the two lower to edges of this panel. meaning bend them inward along there lower edges slightly, or make a crease along that edge, elimanating the sharp edge, is this possible :?: |
16th January 2005, 12:04 PM | #2 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,563
|
Extrude the shape forward (unset all the extrude checkbox options) and shrink the original section.
Andy |
17th January 2005, 06:22 AM | #3 |
Senior Member
Professional user
Join Date: Nov 2004
Posts: 191
|
The first part I understand, the second I don't ... shrink what and how with the xyz or the -10 percent and what does this shrinkage do. Thanks :?:
|
17th January 2005, 08:00 AM | #4 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,563
|
Yes the -10% would be fine but you will have finer control over the scaling if you hold down the control key and resize a corner.
Andy |
Thread Tools | |
Display Modes | |
|
|