14th June 2006, 03:12 AM | #1 |
Member
Expert member
Join Date: Apr 2006
Posts: 91
|
help me
i cant rip off dotlines (bright) rounds top primmery hull. i want normal darklines but i did object>optimizce vertices and surfaces. what else i do? what if i want black lines too.
starship winger Last edited by USSWINGER; 14th June 2006 at 09:36 PM. |
14th June 2006, 07:13 AM | #2 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
Re: help me
Can you post a close-up of the area?
|
14th June 2006, 09:30 PM | #3 |
Member
Expert member
Join Date: Apr 2006
Posts: 91
|
Re: help me
you see outlines with dots that i dont want like this one.. how i can erase dots? wait i show you what i want next thread.
|
14th June 2006, 09:35 PM | #4 |
Member
Expert member
Join Date: Apr 2006
Posts: 91
|
Re: help me
this come with inspect unclean image and editing... how i can put darklines to stay that way?
|
14th June 2006, 09:48 PM | #5 |
Member
Expert member
Join Date: Apr 2006
Posts: 91
|
Re: help me
you see this picture i copy. i want same black lines on rounds and stright lines too.
can you explain me how? thanks... |
15th June 2006, 01:28 AM | #6 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
Re: help me
I think you are just seeing image artifacts from the small image = nothing is wrong with the model. If you switch on anti-alias, you might clean the lines up a bit
I'd either use the texture or an indent, followed by an extrude: Last edited by Andy; 15th June 2006 at 01:30 AM. |
15th June 2006, 05:11 AM | #7 |
Member
Expert member
Join Date: Apr 2006
Posts: 91
|
Re: help me
that look so cool umm i know about rounds lines after revolve. but how stright lines from middle to end round? can you show me how just before object> revolve that all.. thanks!
|
15th June 2006, 06:47 AM | #8 |
Administrator
Professional user
Join Date: Jun 2003
Posts: 4,565
|
Re: help me
I just made a line (two vertices) then pressed control+shift+i a three times to insert some vertices along it (Vertex->Insert-vertices).
Andy |
16th June 2006, 12:32 AM | #9 |
Member
Expert member
Join Date: Apr 2006
Posts: 91
|
Re: help me
i did try follow what you told me but i failed grr i cant do it. lol umm can you tell me step by step like above you made one yesturday. you made this one was easier or hard?
|
|
|