AC3D Forums - View Single Post

Willy · 6th November 2003, 08:22 PM

Hi, I just registered AC3D and now I have a really dumb newbie question.

I have made an object using polyline and revolve (see pic)

http://www.citlink.net/~ckearley/NewbieQuestion.jpg

and now I am trying to figure out how to close the open end(s) by adding a surface (quad) or surfaces (tri) to the vertices there. Can someone please point me in the right direction? I just scanned the PDF manual and I didn't see anything that looked like something I was used to.

Do I have to make poly and then weld it to the object? Is that the way to add these types of endcap surfaces in AC3D?

Thanks

6th November 2003, 08:22 PM	#1
Willy Member Expert member Join Date: Nov 2003 Posts: 57	A really Dumb question... Hi, I just registered AC3D and now I have a really dumb newbie question. I have made an object using polyline and revolve (see pic) http://www.citlink.net/~ckearley/NewbieQuestion.jpg and now I am trying to figure out how to close the open end(s) by adding a surface (quad) or surfaces (tri) to the vertices there. Can someone please point me in the right direction? I just scanned the PDF manual and I didn't see anything that looked like something I was used to. Do I have to make poly and then weld it to the object? Is that the way to add these types of endcap surfaces in AC3D? Thanks