View Single Post
Old 18th July 2014, 11:18 AM   #25
Edymnion
Senior Member
Professional user
 
Edymnion's Avatar
 
Join Date: Aug 2005
Posts: 203
Default Re: Sword of Omens for 3D Printer WIP

Oh yes, much happier with it now that I sat down and redid the grip and pomel.

Gotta admit that I'm constantly fighting my "less is more" instinct when it comes to just throwing more polygons at it, to the point I have to keep reminding myself that this is going to be printed, more is more and I can never have too many polygons. More polygons = smoother print.

Extra good news once the printer gets in though. A better solvent for PLA plastic (what my printer will use) has been found. ABS plastic will dissolve in acetone (fingernail polish remover), which is cheap and easy to get. Makes it easy to set up an acetone vapor bath to smooth prints out. The only real answer for doing the same in PLA was some fairly expensive and toxic stuff. A recently found alternative is MEK/MEK Substitute, which can be bought at any major hardware store as a paint thinner.

Score!
Attached Thumbnails
Click image for larger version

Name:	Image2.jpg
Views:	295
Size:	276.3 KB
ID:	3093  

__________________
It is by caffeine alone that I set my mind in motion. It is by the syrup of cola that thoughts acquire speed, the ears acquire ringing, the ringing becomes a warning. It is by caffeine alone that I set my mind into motion.

Last edited by Edymnion; 18th July 2014 at 11:23 AM.
Edymnion is offline   Reply With Quote