View Single Post
Old 20th September 2020, 04:47 PM   #2
Junior Member
Junior member
Join Date: Sep 2020
Posts: 5
Default Re: Round stock embedded in square stock

two things: I would go to real life and take a look at some basic joinery techniques that would work for you. These look like they have just been stuck in which isn't necessarily a bad thing but it could cause you some problems which brings me to the second thing: I think you should take a look at your work in the wire mesh mode and see if the mixing of the two meshes are going to cause you problems when you join them. You want to avoid as much mesh clean up as possible. This is why researching basic joinery techniqes may come in handy for you. Nice work! Good luck!
catmandolin is offline   Reply With Quote