View Single Post
Old 13th July 2007, 09:38 AM   #1
Junior Member
Junior member
Join Date: Jul 2007
Posts: 6
Default oblique 3-D polylines

I'm just a newbie so perhaps there is an easy way to do this that I couldn't find, but it sure would be nice to be able to snap a line between two 3-D points that are not in a single XY, YZ, or ZX plane. If anybody can give me a clue, I'd sure appreciate it. I had to go through a pile of x,y,and z rotations followed by scaling, cut-away, and delete to get what I wanted. If there is currently no good way to do this, it would be worth adding.

- Mike
michaelward is offline   Reply With Quote