View Single Post
Old 10th July 2020, 12:54 PM   #1
Junior Member
Join Date: Apr 2020
Posts: 10
Default Co ordinate systems

AC3D uses Cartesian coordinates X plane uses airplane co ordinates where X = longitudinal ( roll ) , Y= lateral ( pitch ) and Z = vertical (yaw) . It would be fantastic if AC3D co ords could be set to airplane design mode .

At present front view has z as longdituidinal and shows the back view when importing an obj from planemaker . The result is continual transforms being done in the cranium . The 3D view displays correctly

Any ideas on how this can be done . .?
hedley is offline   Reply With Quote