Re: extrude along path with assembled lines
Thanks Andy for reply.
First, my actual working method:
placing a line with much more vertices (than I'm thinking to need) on the floor.
Afterwards, I can move them to the right position comfortably.
---------
"select the vertices in the correct order and create a single surface from the vertices."
How to create a SINGLE surface?
----------
"hold shift and control, then drag over the vertices with the left mouse button down. "
works,
but what to do afterwards, same as above?
Greetings, Gogo
PS: the mentioned "problem" is, that, if I'm using the mouse for some window-moving-zooming, the line-command is finished
-----
T select = texture on/off?
Last edited by gogosAC; 21st September 2022 at 04:12 PM.
|