Re: A couple of alignment questions...
Did a search and came across this inquiry by Stiglr. I would like to be able to rename the "Front (XY)" to "Right (XY)" and "Left (ZY)" to be renamed "Back (ZY)". This is just for this project. Starting to make a Manitowoc 4000W Crawler Crane. The right side of crane is where the cab is and the boom is attached at the front of the crane. The Counterweights are attached at the back end. I wonder since 2006 if anything was done to be able to rename the viewports. So glad to see X64 version.
|