View Single Post
Old 23rd October 2013, 11:31 PM   #7
Senior Member
Professional user
Edymnion's Avatar
Join Date: Aug 2005
Posts: 203
Default Re: Sword of Omens for 3D Printer WIP

Okay, almost finished with this one.

Exterior mesh just requires the filigree around the base of the pommel and everything will be done.

After that, its just a matter of continuing to break up the sword into printable size pieces. You can see I've already started that, but I still need to section up the blade and pull off the crossguards.

If you're sharp eyed, you may notice that I also have the slot for the steel bar in place as well.

Hoping to have everything completely finished and ready to go by the weekend. Then it'll only be... about 4 months before I get the printer. :P
Attached Thumbnails
Click image for larger version

Name:	Image1.jpg
Views:	495
Size:	214.7 KB
ID:	2919  

It is by caffeine alone that I set my mind in motion. It is by the syrup of cola that thoughts acquire speed, the ears acquire ringing, the ringing becomes a warning. It is by caffeine alone that I set my mind into motion.
Edymnion is offline   Reply With Quote