AC3D Forums - View Single Post

DarkMesh · 10th September 2011, 03:41 PM

Hi everyone, just bought AC3D and really enjoying it so far. I'm somewhat new to 3D modelling and I have been working on this model of an Axe for a bit and was looking for some advice on what method I could use to join the blade with the handle, or actually what I guess is the poll or butt of the Axe and the eye that the handle fits into. Anyway, any suggestions at all about this model would be greatly appreciated. Thanks!

10th September 2011, 03:41 PM	#1
DarkMesh Junior Member Junior member Join Date: Sep 2011 Posts: 5	My First Axe needs help Hi everyone, just bought AC3D and really enjoying it so far. I'm somewhat new to 3D modelling and I have been working on this model of an Axe for a bit and was looking for some advice on what method I could use to join the blade with the handle, or actually what I guess is the poll or butt of the Axe and the eye that the handle fits into. Anyway, any suggestions at all about this model would be greatly appreciated. Thanks! Attached Thumbnails Last edited by DarkMesh; 10th September 2011 at 03:43 PM.