AC3D Forums - View Single Post

Krahazik · 21st September 2017, 02:18 PM

I have run into a problem on a project and I do not know where to go to evenfind the answer.
The problem is one of design translation I guess.
I have design a wooden part in 3d using AC3D.

How do I translate the 3d model into something a Carpenter can use to build the part? At this point assuming manual construction methods.

21st September 2017, 02:18 PM	#1
Krahazik Junior Member Member Join Date: Jan 2016 Location: Washington State, USA Posts: 10	I have a development question. I have run into a problem on a project and I do not know where to go to evenfind the answer. The problem is one of design translation I guess. I have design a wooden part in 3d using AC3D. How do I translate the 3d model into something a Carpenter can use to build the part? At this point assuming manual construction methods.