Hawk,
I get the same results as luuckyy if I turn on "clean" view, and I get the same results as you if I leave it on normal view.
What you're seeing is 2 surfaces in the center of the mirrored box.
To get rid of these, you have 2 options --- the easiest is to remove the surface on the right side of the box (the side where you're mirroring) before you actually perform the mirror.
The second option, if you already have the box created, is to follow luuckyy's creation steps, but at the end, do this:
1. Select the entire mirrored box.
2. Enter Surface mode
3. In the Front view, Shift + right-drag over the surfaces on the left and then to the right of the center line. You should be left with only the center line/surfaces selected. You can now delete these.
Let us know if that makes sense.
Either of these approaches should get rid of the line you're seeing.
Dennis
|