AC3D Forums - View Single Post

AllenAnway · 28th February 2011, 01:11 PM

Many thanks for your efforts to help. What I wanted was to puncture the surface of revolution by the cylinder to be able to see into the interior of the surface. Is this possible to do? I am modeling an electrical housing Red Dot GALB-2 and it has two threaded bushings into which 3/4" pipe threaded pipe nipples are screwed in. Thanks again for your interest --- A2D2

28th February 2011, 01:11 PM	#3
AllenAnway Junior Member Junior member Join Date: Feb 2011 Location: Superior, WI Posts: 5	Re: Make a hole in a surface Many thanks for your efforts to help. What I wanted was to puncture the surface of revolution by the cylinder to be able to see into the interior of the surface. Is this possible to do? I am modeling an electrical housing Red Dot GALB-2 and it has two threaded bushings into which 3/4" pipe threaded pipe nipples are screwed in. Thanks again for your interest --- A2D2 __________________ A2D2