View Single Post
Old 19th September 2020, 04:11 PM   #1
Advanced member
Join Date: Jan 2013
Location: West Coast, US
Posts: 38
Default Round stock embedded in square stock

Hi there,I have been building a section of a boom for a crane. Today for the first time, where the cylinder embeds into a square section, the joint doesn't look right. Have attached two pictures, (#1) the bad area and what it should look like (#2). Edit: solved the problem with Surface Flip.
Attached Images

Last edited by uffdaken; 20th September 2020 at 01:30 PM.
uffdaken is offline   Reply With Quote