Go Back   AC3D Forums > General > AC3D General
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 5th August 2011, 12:03 PM   #1
Junior Member
Junior member
Join Date: Aug 2011
Posts: 4
Default crease angle: smaller instead of larger?

I've just downloaded the trial. Here's a quote from the manual:
The angle between adjacent surfaces is measured and if this is larger than the crease angle the surfaces will be smoothed.
Shouldn't it be "smaller" instead of "larger"? It goes on to say that a value of 0 would "force all surfaces to be flat", i.e., would produce NO smoothing. But if angles _larger_ than 0 should be smoothed, it should smooth everything.
rogue is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -4. The time now is 12:35 PM.

AC3D Forum
(C) Inivis Limited 2020