A really Dumb question...

[Willy]

Hi, I just registered AC3D and now I have a really dumb newbie question.

I have made an object using polyline and revolve (see pic)

http://www.citlink.net/~ckearley/NewbieQuestion.jpg

and now I am trying to figure out how to close the open end(s) by adding a surface (quad) or surfaces (tri) to the vertices there. Can someone please point me in the right direction? I just scanned the PDF manual and I didn't see anything that looked like something I was used to.

Do I have to make poly and then weld it to the object? Is that the way to add these types of endcap surfaces in AC3D?

Thanks