Using the TCE

[INNIS]

Hi Guys
Could someone tell me when I am using the TCE how I can move around
the texture when I am vooming in.
I find that I remain in the centre of the texture.So if I have a small texture
in a corner I need to voom in on to map i can't do it.
So is this possible with the TCE.
I am using AC3D 3.6.

Thanks for any help

Cheers
Innis

[-WOODY-]

Hold down your middle mouse button just like in ortho view.

[INNIS]

Thanks Woody for the reply but I only have a two button mouse.Is there
any other way to do it.

Cheers
Innis

[-WOODY-]

Oh, then that would be control+right mouse button.

[Thaellin]

You can also hold both mouse buttons - if you press them at the same time, it acts like a middle button.
-- Jeff

[INNIS]

Thanks Guys for the suggestions but none seem to work.
The mouse has a control wheel which probably takes the place of
the centre button.
I may have to fit a three button mouse and see if that works
Thanks again.

cheers
Innis

[Thaellin]

Standard wheel mice allow you to press down the wheel - voila: middle button.

Yours may not, of course.
-- Jeff

[INNIS]

Thanks Jeff but when I press the wheel a round wheel comes up with selections like are on the tool bar.

Thanks anyway.

Cheers
Innis

[Andy]

The button-wheel on my MS optical wheel mouse does this scrolling thing in explorer and other programs but works fine as a third button in AC3D.

Does rotating the wheel zoom the views?

BTW - nice forum avatar Woody!

Andy

[INNIS]

No Andy it does nothing.
If I hold the right button down I can zoom in and out but nothing I have tried on the mouse or keyboard will allow me to move sideways or up and
down. :?:
Can I move sideways and up and down using the keyboard or does this
only work with the mouse.

Thanks for your suggestions.

Cheers
Innis