Mirror without unifying

[gogosAC]

Hello Andy,

could it be possible to add
a mirror-cmd without unifying the objects?

I mostly need the mirrored object separatly.

Greetings gogo

[Andy]

It would be possible but it would add a lot to an already complicated menu and may be confusing for some.


How about selecting all the new surfaces then using Surface->Cut-Away-Object? That should perform the same function.

[gogosAC]

Hello Andy

Unfortunately not.

Example:
Complex front of a bus,
consisting of 3 objects (front, side, roof).

These should be retained when mirroring -> similar rear of the bus,
for further processing of the 3 objects.

In addition, the texture is also lost during the "cut-away".

I use this type of mirroring very often.

I achieve my goal with a few more work steps,
and would have liked it to be easier.

All good.

Greetings Gogo