filling gaps (holes) in surfaces

uani · 30th August 2013, 02:53 PM

Thank you!

I couldn't cut away from the intersecting cylinder and join the remainder to the wheel Frame because the cylinder was left in a displaced state like after the Union.

However I could cut away holes into the wheel Frame using the intersecting cylinder as the knife and join a new cylinder after moving the cap Vertices (I actually used no cap) into Position.

Thank you!

30th August 2013, 02:53 PM	#3
uani Junior Member Junior member Join Date: Aug 2013 Posts: 4	Re: filling gaps (holes) in surfaces Thank you! I couldn't cut away from the intersecting cylinder and join the remainder to the wheel Frame because the cylinder was left in a displaced state like after the Union. However I could cut away holes into the wheel Frame using the intersecting cylinder as the knife and join a new cylinder after moving the cap Vertices (I actually used no cap) into Position. Thank you!