Go Back   AC3D Forums > General > AC3D General
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Display Modes
Old 19th September 2020, 04:11 PM   #1
uffdaken
Member
Advanced member
 
Join Date: Jan 2013
Location: West Coast, US
Posts: 38
Default Round stock embedded in square stock

Hi there,I have been building a section of a boom for a crane. Today for the first time, where the cylinder embeds into a square section, the joint doesn't look right. Have attached two pictures, (#1) the bad area and what it should look like (#2). Edit: solved the problem with Surface Flip.
Attached Images
  

Last edited by uffdaken; 20th September 2020 at 01:30 PM.
uffdaken is offline   Reply With Quote
Old 20th September 2020, 04:47 PM   #2
catmandolin
Junior Member
Junior member
 
Join Date: Sep 2020
Posts: 5
Default Re: Round stock embedded in square stock

two things: I would go to real life and take a look at some basic joinery techniques that would work for you. These look like they have just been stuck in which isn't necessarily a bad thing but it could cause you some problems which brings me to the second thing: I think you should take a look at your work in the wire mesh mode and see if the mixing of the two meshes are going to cause you problems when you join them. You want to avoid as much mesh clean up as possible. This is why researching basic joinery techniqes may come in handy for you. Nice work! Good luck!
catmandolin is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -4. The time now is 11:36 AM.


AC3D Forum
(C) Inivis Limited 2020