|
8th February 2019, 04:01 PM | #1 | |
Member
Expert member
Join Date: Feb 2012
Posts: 58
|
Re: extruding a polygon 8.0.80 can't get endcap, what am I doing wrong?
Quote:
I just ran into this problem yet again I see that the "thicken" function replaces the extrude for the endcaps. It is of very poor design to not be backward compatible to what we are used to for the past 10 years. there is absolutely no good reason that you don't leave the extrude endcaps and have it simply do the thicken function. or if that is too difficult, leave the endcap check box greyed out, and when you click on it you get a pop-up explaining that this function has been depreciated and replaced with the thicken button. It is not a good Idea to change your loyal customers workflow. At least I can come to the forum and find out what is going on. I understand your thought to try and attract other customers that "are used to" something different, however the reason I use AC3D INSTEAD of the others software is because I LIKE the way you do things instead of their way. Don't sacrifice your customer base for an attempt to add new ones. I cannot believe adding thicken required you to eliminate the endcaps. By leaving endcaps you would of pleased your customer base AND conformed to other software. Last edited by jleslie; 8th February 2019 at 04:06 PM. |
|
|
|